Cable Shears D20

	P/N	R700 020 3 (Plastic Coated) R700 020 36 (Reinforced Plastic Grips)
	Description	For cutting copper and aluminium cables, single and multiple wire Not suitable for steel wire and hard drawn copper conductors No crushing, no deformation Initial and final cut (1st and 2nd blades) allow cables with a diameter of up to max. 25 mm Ø (1 inch) to be cut Sharp, hardened, precision-ground blades Easy, clean cut with one-hand operation Adjustable joint screw Not suitable for steel wire Material: special tool steel, forged Made in Germany by Rennsteig

• Low effort required due to high transmission ratio and new blade geometry
• Precision ground, hardened blades
• Clean and smooth cut without crushing and deformation
• Easy cutting with one-hand operation
• Initial and final cut (upper and lower blade) allows cables of up to 20 mm dia. to be cut
• Low handforce required due to favorable lever ratio and new blade geometry
• With guard
• Adjustable screw joint, self-locking
• Forged
• Special tool steel, oil-hardened and tempered
• Made in Germany by Rennsteig

 

The use of the front blade means that an ergonomic handle width is retained even when handling large diameter.	If greater force is required, it is possible to adjust the profile at the joint. Initial cut at the front, final cut at the rear.

 

Plastic Coated Version

Reniforced Plastic Grips