Chisels for Metallworking

P/N 421 000 0

  • Set of 6 pieces
  • 2 Flat Cold Chisels (6" and 5" long)
  • 1 Crosscut Chisel (5" long)
  • 1 Starter (Taper) Punch (4 3/4" long, point size Ø 3mm - similar to 1/8")
  • 1 Starter (Taper) Punch (4 3/4" long, point size Ø 4mm - similar to 5/32")
  • 1 Center Punch (4 3/4" long)
  • Also available in plastic case or metal case
  • Industrial quality, meets standard DIN 7254

Request a Quote!

  • Forged chisels quenched and tempered as a whole to guarantee a good reliliency and to resist hard working stress thus offering a long service life.
  • For chasing, cutting and slitting
  • Chrome-Vanadium-steel
  • Hardened and tempered (safety striking head)
  • Regrindable cutting edge
  • Shank gold-colored
  • Industrial quality, meets standard DIN 7254

  • Made of hardened chrome vanadium steel
  • Forged chisels quenched and tempered as a whole to guarantee a good reliliency and to resist hard working stress thus offering a long service life
  • Chisel blades are polished or laquered
  • Shanks dip coated in gold lacquer
  • Industrial quality, meets standard DIN 7254

  • For chasing, cutting and slitting
  • This is the perfect tool for removal-replacement of old floor and trunk pans!
    • After you drill out the factory weld spots where the two pieces overlap, this chisel easily separates them.
  • Working end bent 25° - better clearance
  • Optimal geometry of cutting edges
  • 2nd cutting edge on the side
  • Chrome-Vanadium-steel
  • Hardened and tempered (safety striking head)
  • Regrindable cutting edge
  • Shank gold-colored
  • Industrial quality, meets standard DIN 7254

Main Menu